Honeywell scheda di rete HC900 Manuale

Manuali PDF
228 Pagine Italiano

Honeywell scheda di rete HC900
Communications Installation - RS-485 Link to Operator Interface
102 HC900 Hybrid Controller Installation and User Guide Revision 5
9/03
Step Procedure
8
Select the Set Controller’s Network Parameters button. Using the wizard (bottom radio button),
select the PC port to be used, then set the controller’s new network parameters including IP address,
Subnet Mask (if other than the default), and Default Gateway IP address (if required, otherwise use
default). Refer to the HC900 Hybrid Control Designer User’s Guide or its respective on-line help,
Utilities Worksheet - Set Controller’s Network Parameters, for further details on this step.
Note: This step will require the controller to be placed temporarily in the Program mode. After the
new network parameters have been downloaded, the controller will conduct a Cold Start in its
transition to RUN. This will cause an initialization if there is a current configuration in the controller.
Manuali Correlati per Honeywell scheda di rete HC900